Made in the USA - Flat Rate Shipping $17.95!

Polylok Complete 24" Riser Kit (4" Tall)

Part Number
24R2-KIT

The Polylok 24" riser kit comes complete with everything needed to install a septic tank riser system in your application. This package gives you approximately 4" in height. Additional 24" Polylok risers can be purchased and stacked on to this kit.

Includes:

  • Polylok 20"/24" Riser Adapter Ring (PN: 3009-AR)
  • Polylok 24" x 2" Riser (PN: 3008-GR2)
  • Polylok 24" Riser Cover rated at 500 lbs. (PN: 3008-RC)
  • Polylok Adapter Ring Installation Anchor Kit (PN: 3009-KIT-NG)
  • #10x1-1/2” stainless steel square drive screws


Optional 24"x12", 24"x6", 24"x3", and 24"x2" risers are available for this kit.


Optional 24" riser gaskets (PN: 3008-HR) are available for this kit.


Installation Instructions:

1. Locate adapter ring over access opening on top of tank
2. Using a 1/4" masonry bit, drill 8 holes 1-1/4" deep on top of tank
3. Clean under surface of adapter ring apply foam gasket or butyl
4. Position adapter ring over opening, using 1/4" anchors, tap anchors into drilled holes and tighten with wrench
5. Position appropriate riser and or cover and screw onto the adapter ring to provide a watertight connection

Note: These items should be installed by a professional septic tank installer or pumper.  These are not intended to be installed by a homeowner.

Copyright © 2024 Zabel Environmental, all rights reserved.